Ricoh Ri 1000 Manual page 10

rests against the corner of the carriage.
The pawl on the side of the carriage that is not visible because it is in the shadow of
the carriage should be handled with the head protection cover parallel to the guide rod
and carriage, so that when the two pawls on the right side of the head protection
cover are aligned with the mounting position, they are simultaneously aligned with the
mounting position. the two pawls on the right side of the head protection cover can be
aligned to the mounting position at the same time
4.Take the filled cleaning liquid with the head protection cover under the
carriage to prevent spillage
If cleaning solution spills when the head protection cover is pushed up, wipe it off.
After attaching the head protection cover, observe it from the front and check if the
head protection cover is not tilted.
If it is tilted, a gap may be visible between the carriage and the cap inside the head
protection cover, as shown in the NG image below. In this case, perform the
Procedure for long-term storage
10 / 22
RICOH Ri 1000