Page 1
Ethernet Paging Microphone Thank you for choosing another quality product from Amperes Electronics. Amperes iPD1280, an ethernet version of PD1280 has been further improved with more responsive touch panel and other fixes to enhance the overall performance of the device.
Page 2
Microphone output level can be adjusted according to site requirement. 13. RESET BUTTON Button for resetting the unit to factory default. Use only when required as setting done previously would be lost. 14. POWER SWITCH Power switch for the unit. PAGE 2 iPD1280 | ETHERNET PAGING MICROPHONE...
Page 3
DECODER POWER AMPLIFIERS (Output Mode) Music / Paging Audio ETC. Data SUB RACK Note: In a system, only one iPX5101 is required, no matter the size of the system or the number of clients installed. PAGE 3 iPD1280 | ETHERNET PAGING MICROPHONE...
Page 4
All network related information of the device. Paging Server Status Shows connectivity of the device to the paging server ( Amperes iPX5101 ) and its IP address. NETWORK CONFIGURATION IPV4 Configuration IP address setting is required for this page, namely the device’s IP address and the Gateway address.
Page 5
Device access setting to prevent unauthorized access to setting page. Update Firmware Firmware update .. refer to page 10. Backup & Restore For back up configuration to external file and to retrieve settings from saved file. PAGE 5 iPD1280 | ETHERNET PAGING MICROPHONE...
Page 6
FILO, or as Press ‘ADD’ to select value preset at the paging server, (AOLP Once priority level setting). 1.2 Priority Set : 2 determined, press ‘0’ Press “0” for Save Return to PRIORITY menu PAGE 6 iPD1280 | ETHERNET PAGING MICROPHONE...
Page 7
5.1 PAGING TIMEOUT 5.2 DISPLAY TIMEOUT Press ‘CLR’, Return to “CLR” 1min 1min main menu “0” and “ADD” to modify “0” and “ADD” to modify the time out duration the time out duration PAGE 7 iPD1280 | ETHERNET PAGING MICROPHONE...
Page 8
9. SAVE AND EXIT factory defaults. Press “0” to enter the menu. Press “0” 9. SAVE AND EXIT Press ‘CLR’, Return to Main Menu “ADD” to select Yes or No and press “0” PAGE 8 iPD1280 | ETHERNET PAGING MICROPHONE...
Page 9
Talk when the LED ring at the mic is lit and to end, To end call, press “Chime + Talk” press “Chime + Talk” Group paging can be mixed with individ- ual zone call. PAGE 9 iPD1280 | ETHERNET PAGING MICROPHONE...
Page 10
There are two methods of firmware updatings : Update firmware in Normal Operation Mode 1. Open a browser and type in the iPD1280 IP Address. The default address is 192.168.0.100. 2. Under “System” page look for “Update Firmware” section as shown in below.
Page 11
230 x 192 x 65 mm ( Excluding Mic) Weight 850 g Note: The above specifications are correct at time of printing, but subject to changes without prior notice due to product improvements. PAGE 11 iPD1280 | ETHERNET PAGING MICROPHONE...
Page 12
Only Amperes Electronics Service Centres are allowed to make warranty repairs : a list of Amperes Electronics authorized service centres may be asked by the purchaser or send directly to Amperes Electronics Sdn Bhd at 70 Jalan Industri PBP3, Tmn Perin- dustrian Pusat Bandar Puchong, 47100, Puchong, Selangor.
Need help?
Do you have a question about the iPD1280 and is the answer not in the manual?
Questions and answers