Advertisement
III. Installation Continued...
Converting to LP Gas Continued...
A flexible metal appliance connector used to connect the cooktop to the gas supply line
should have an I.D. of 1/2" and be 5 feet in length for ease of installation. In Canada, flexible
connectors must be single wall metal connectors no longer than 6 feet in length.
ADAPTING THE COOKTOP FOR DIFFERENT TYPES OF GAS
To adapt the cooktop to a different type of gas than that for which it was designed, (see the
sticker under the hob or on the package), the burner nozzles must be changed, as follows:
Conversion must be done by a trained professional.
Remove the pan supports and slide the burners out of the cooktop.
Unscrew the nozzles using a 7mm socket wrench and replace them with those for the new
type of gas.
Reassemble the parts following the instructions in reverse order.
On completing the operation, replace the old rating label with the one showing the new type
of gas; the sticker is available from our SERVICE CENTRES.
IF THE GAS PRESSURE IS DIFFERENT THAN THAT PRESCRIBED, A PRESSURE REGULATOR
MUST BE INSTALLED AT THE SOURCE, IN COMPLIANCE WITH NATIONAL STANDARDS GOV-
ERNMENT THE USE OF PIPED GAS REGULATORS.
To complete the conversion, follow up below:
Replacement of the burner injectors
Regulation of the burner flame level
TI-1G & TI-2G GAS COMBO COOKTOP MANUAL
Leak test
REPLACEMENT OF THE BURNER INJECTORS
Remove the gratings and the burner covers;
Using a wrench, substitute the nozzle injectors; "J" (Fig.20) with
the pair provided in the small bag.
P.
12
Advertisement
