PST MI414 User Manual

On Sample Reading
• "-SA-: there is too much light for
the sample measurement. Please
check if the right sample cuvette
is inserted.
• "Inv: the sample and the zero
cuvette are inverted.
• "ZErO'. a zero reading was not
taken. Follow the instruction in
the measurement procedure for
zeroing the meter.
·o.o·
• Under range. A blinking
indicates that the sample
absorbs less light than the zero
reference. Check the procedure
and make sure you use the same
cuvette for reference (zero) and
measurement.
• A flashing value of the maximum
concentration indicates an over
range condition. The concentration
of the sample is beyond the
programmed range: dilute the
sample and re-run the test.
BATTERY REPLACEMENT
Battery replacement must only take place in a non­
hazardous environment.
Simply rotate the battery cover on the back of the meter.
Detach the battery from the terminals and
attach a fresh 9V battery while paying
attention to the correct polarity.
Insert the battery and replace
G�
the cover.
. � ,,).:,
Ii, · ""
ACCESSORIES
Chloride reagent set (100 tests)
Ml514-100
Glass cuvette (2 pcs)
MI000I
Caps for cuvettes (2 pcs)
MI0002
Stoppers for cuvettes (2 pcs)
MI0003
CERTIFICATION
Milwaukee Instruments conform to the CE
- SR-I
European Directives,
Disposal of Electrical
Equipment.
household waste. Hand it over to the
lnu J
appropriate collection point for the recycling
of electrical and electronic equipment.
Disposal of waste batteries. This product
cE,al
contains batteries. Do not dispose of them
with other household waste. Hand them
over to the appropriate collection point for recycling.
Please note: proper product and battery disposal
prevents potential negative consequences for human
health and the environment. For detailed information,
contact your local household waste disposal service or
go to
www.milwaukeeinstruments.com
or
www.milwaukeeinst.com.
RECOMMENDATION
Before using this product, make sure
for your specific application and for the environment in
which it is used. Any modification introduced by the user
to the supplied equipment may compromise the meter's
performance. For your and the meter's safety do not use
or store the meter in hazardous environment. To avoid
damage or burn, do not perform any measurement in
microwave ovens.
WARRANTY
This instrument is warranted against defects in materials
and manufacturing for a period of 2 years from the
date of purchase. This warranty is limited to repair or
•
• ,.s
free of charge replacement if the instrument cannot be
__/
o/
•
repaired. Damage due to accidents, misuse, tampering
or lack of prescribed maintenance is not covered by
warranty. If service is required, contact your local
Milwaukee Instruments Technical Service. If the repair is
not covered by the warranty, you will be notified of the
charges incurred. When shipping any meter, make sure it
is properly packaged for complete protection.
ISTMl414 01/21
CE
& Electronic
RoHS
Do not treat this product as
compliant
-
(USA & CAN)
is entirely suitable
it
. �
I
SATISFACTION
V GUARANTEED
USER MANUAL
Ml414
PRO Chloride
Photometer
Distributor in Australia
Pacific Sensor Technologies Pty Ltd
Unit 4, 3 Neutron Place Rowville, VIC 3178 Australia
1300 662 720 | sales@pacificsensortech.com.au
www.pacificsensortech.com.au
@)
milwaukee