Other Printing Problems - Ricoh Aficio SPC220N Hardware Manual

Troubleshooting

Other Printing Problems

Toner smears appear on the
print side of the page.
Paper jams occur frequently.
7
Prints fall behind the machine
when they are output.
Prints do not stack properly.
82
Status
The paper setting may not be correct. For example, although
you are using thick paper, the setting for thick paper may not
be set.
• Check the printer driver's paper settings.
Confirm that the paper is not curled or bent. Envelopes can
be curled easily. Flatten paper before loading.
See p.23 "Paper and Other Media".
• Number of paper set in the tray exceeds the limit. Con-
• There may be a gap between the front end paper guide
• Paper is either too thick or too thin.
• Paper is bent or wrinkled. Use paper that has no bents or
• Paper has already been printed on.
• Paper is damp. Use paper that has been stored properly.
• The friction pad, or paper feed roller or registration roller
Raise the appropriate stop fence (forward fence for A4, rear
fence for legal size prints).
See p.1 "Exterior: Front View".
• Paper is damp. Use paper that has been stored properly.
• Pull out the extender.
• Log on to Smart Organizing Monitor as an Administra-
• Raise the appropriate stop fence (forward fence for A4,
Possible Causes, Descriptions, and Solutions
See the printer driver Help.
firm that the top of the stack is not higher than the limit
mark inside the tray.
See p.34 "Loading Paper".
and the paper, or between the paper guide both side and
the paper in the paper tray. Make sure there are no gaps.
See p.34 "Loading Paper".
See p.23 "Paper and Other Media".
wrinkles.
See p.23 "Paper and Other Media".
See p.23 "Paper and Other Media".
See p.23 "Paper and Other Media".
might be dirty. Clean the relevant component.
See p.66 "Cleaning the Friction Pad and the Paper Feed
Roller", and p.69 "Cleaning the Registration Roller".
See p.23 "Paper and Other Media".
tor, and then select [Mode 2] or [Mode 3] in the [Anti-humid-
ity:] list on the [System] tab. Note that the first print takes
longer than subsequent prints to complete.
rear fence for legal size prints).
See p.1 "Exterior: Front View".