HP EliteBook x360 1040 Maintenance And Service Manual page 48

Before removing the battery, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
WARNING!
computer, a replacement battery provided by HP, or a compatible battery purchased from HP.
IMPORTANT:
information. To prevent loss of information, save your work or shut down the computer through
Windows before you remove the battery.
Remove the battery:
1. Disconnect the battery cable (1) from the system board.
2. Remove the four Phillips M2.0 × 4.5 screws (2) that secure the battery to the computer.
3. Swing the rear edge of the battery (3) up and forward until it rests at an angle.
4. Remove the battery (4) by sliding it up and back at an angle.
To install the battery, reverse the removal procedures.
WWAN module
To remove the WWAN module, use this procedure and illustration.
Table 5-3 WWAN module descriptions and part numbers
Description
Intel 5000 5G WWAN module
Intel XMM 7560 R+ LTE-Advanced Pro (Cat 16) WWAN module
WWAN antenna (includes WWAN aux cable and transceiver)
IMPORTANT:
module authorized for use in the computer by the governmental agency that regulates wireless
42 Chapter 5 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
To reduce potential safety issues, use only the user-replaceable battery provided with the
Removing a battery that is the sole power source for the computer can cause loss of
To prevent an unresponsive system, replace the wireless module only with a wireless
Preparation for disassembly on page
39).
39).
Spare part number
N00181-002
N00182-002
N13696-001