Advertisement
9.1 What to do if...
Problem
You cannot activate or oper‐
ate the hob.
Hob²Hood does not work.
There is no sound when you
touch the panel sensor
fields.
The flexible induction cook‐
ing area does not heat up
the cookware.
Possible cause
The hob is not connected to
an electrical supply or it is
connected incorrectly.
The fuse is blown.
Pause operates.
You covered the control pan‐
el.
You use a very tall pot which
blocks the signal.
The sounds are deactivated. Activate the sounds. Refer to
The cookware is in a wrong
position on the flexible in‐
duction cooking area.
The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.
FlexiBridge operates. One or
more sections of the function
mode which operates are
not covered by the cook‐
ware.
ENGLISH
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec‐
tion diagram.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Refer to "Daily use".
Remove the object from the
control panel.
Use a smaller pot, change
the cooking zone or operate
the hood manually.
"Daily use".
Place the cookware in the
correct position on the flexi‐
ble induction cooking area.
The position of the cookware
depends on the activated
function or function mode.
Refer to "Flexible induction
cooking area".
Use cookware with a diame‐
ter applicable to the activa‐
ted function or function
mode. Use cookware with a
diameter smaller than 160
mm on a single section of
the flexible induction cooking
area. Refer to "Flexible in‐
duction cooking area".
Place the cookware on the
correct number of sections
of the function mode which
operates or change the func‐
tion mode. Refer to "Flexible
induction cooking area".
21
Advertisement
