Advertisement
The function can be activated for the
induction cooking zone only for a limited
period of time. After this time the
induction cooking zone automatically
sets back to the highest heat setting.
Refer to "Technical data"
chapter.
To activate the function for a cooking
zone: touch
.
To deactivate the function: change the
heat setting.
5.6 OptiHeat Control (3 step
Residual heat indicator)
WARNING!
/
/
indicator is on, there is a risk
of burns from residual heat.
The induction cooking zones produce the
heat necessary for the cooking process
directly in the bottom of the cookware.
The glass ceramic is heated by the heat
of the cookware.
The indicators appear when a cooking
zone is hot. They show the level of the
residual heat for the cooking zones you
are currently using:
- continue cooking,
- keep warm,
- residual heat.
The indicator may also appear:
• for the neighbouring cooking zones
even if you are not using them,
• when hot cookware is placed on cold
cooking zone,
• when the hob is deactivated but the
cooking zone is still hot.
The indicator disappears when the
cooking zone has cooled down.
5.7 Timer
Count Down Timer
Use this function to specify how long a
cooking zone should operate during a
single cooking session.
As long as the
Set the heat setting for the selected
cooking zone and then set the function.
You cannot activate the
function while the Hob²Hood
function is running.
1. Press
. 00 appears on the timer
display.
2. Press
or
to set the time (00-99
minutes).
3. Press
to start the timer or wait 3
seconds. The timer begins to count
down.
To change the time: select the cooking
zone with
and press
To deactivate the function: select the
cooking zone with
remaining time counts back to 00.
The timer finishes counting down, a
signal sounds and 00 blinks. The cooking
zone deactivates. Press any symbol to
stop the signal and blinking.
Minute Minder
You can use this function when the hob
is activated but the cooking zones do not
operate. The heat setting shows 00.
You cannot activate the
function while the Hob²Hood
function is running.
1. Press
.
2. Press
or
to set the time.
The timer finishes counting down, a
signal sounds and 00 blinks. Press any
symbol to stop the signal and blinking.
To deactivate the function: press
and
. The remaining time counts back
to 00.
5.8 Power management
If multiple zones are active and the
consumed power exceeds the limitation
of the power supply, this function divides
the available power between all cooking
zones (connected to the same phase).
The hob controls heat settings to protect
the fuses of the house installation.
ENGLISH
11
or
.
and press
. The
Advertisement
