Advertisement
4. SET UP PROCEDURE
4.2 Setting up the Printer
CAUTION!
1. Place the printer on a flat, stable surface.
2. Do not place the printer close to a heater or where it may be exposed to direct sunlight.
3. Avoid locations where the printer may be exposed to high temperature, high humidity or dust.
4. Care must be taken that no condensation occurs in the printer. If it should, however, do not turn
ON the power supply until the condensation is dried.
5. Use a grounded electrical outlet. Do not use an adapter plug.
6. Be sure that there is adequate room around the printer for easy operation and maintenance.
7. Keep your work environment static free.
1)
Make sure that the printer does not connect to power supply.
2)
Connect the adapter cable to the printer.
3)
Insert the power cord into the AC inlet.
4)
Connect the interface cable to a POS terminal, and plug in the power cord to the AC outlet.
5)
If a drawer is desired to be connected, connect the drawer interface cable to the printer.
6)
Secure the drawer ground wire to the ground terminal on the rear of the printer.
7)
Turn the printer power ON by switching on the power supply.
8)
Open the printer cover.
9)
Load the receipt roll into the printer.
10)
Close the printer cover.
11)
Check the print quality by performing an Offline Diagnostic.
12)
Install the printer driver given into POS terminal.
13)
Connect the correct interface cable to the printer and the POS terminal.
Now the printer is ready for printing
NOTES:
For details of the above steps 1) to 4), refer to Section 5.1 "Connecting the Power Cord and
1.
Interface Cables".
2.
Steps 5) and 6) are the procedures of the drawer connection. For details of Steps 5) and 6),
refer to Section 5.1.6 "Connecting via Cash Drawer".
For details of Steps 8) to 10), refer to Section 5.3 "Loading the Receipt Roll".
3.
For details of Step 11), refer to Section 6.0 "Diagnostic".
4.
For details of step 12), refer to Section 5.4 "Driver Installation".
5.
4.3 Turning off the Printer
1)
Open the printer cover by pulling the lever up.
Press and hold the feed button for 5 seconds until double 'beep' sound. During pressing, the printer
2)
will produces first 'beep' sound and followed by double 'beep' sound.
3)
LED light will turn off indicates the printer is turned off.
4)
Close back the top cover.
5)
To turn on the printer back, press the feed button again and the LED will light up.
.
4-2
4.2 SETTING UP THE PRINTER
Advertisement
