Advertisement
6. DIAGNOSTICS
6. DIAGNOSTICS
6.1 Offline Diagnostic
While the printer cover is open, press and hold the feed button until the printer beeps once. Close the
cover and the printer prints the configuration form. Press feed button by a short press to enter offline
diagnostic mode or press it long to exit to online mode.
In 203dpi model, it always prints in Font 1 in Offline Diagnostic regardless of the font setting.
6.2 Main Menu
Once it enters offline diagnostic mode, it prints main menu as follows.
Model number
Serial number
Boot Firmware
Main Firmware
Table Firmware
Font (SBCS)
Offline Diagnostic (Main Menu) ***
To select an option, press the key by a short press
followed by a long press.
To Exit Offline Diagnostic
To Print Config. Form
To Change Settings
To Clear User Define Data
To Reset to Default Settings -> 4 clicks
To Print Maintenance Info.
To Change RS232 Settings
or
To Change Ethernet Settings -> 6 clicks
Pressing the key by a short press followed by a long press according to the guidance on the menu
executes following diagnostic.
To Exit Offline Diagnostic
It exits Offline Diagnostic mode and it goes to online mode after the reset.
To Print Config. Form
It prints the printer configuration form. After that, it will go back to Main Menu printout.
To Change Settings
It goes to Sub Menu that guides an operator to change the printer setting.
To Clear User Define Data
It clears all user define data. After that, it will go back to Main Menu printout.
To Reset to Default Settings
It changes all the settings to the default value and it goes to Final Confirmation Menu.
To Print Maintenance Info.
It prints Maintenance Information Form. After that, it will go back to Main Menu printout.
To Change RS232 Settings or Ethernet Settings
It goes to Sub Menu that guides an operator to change option interface setting.
: xxxx-xxxx-xxxx
: 1234567890
: V00.11 / C79F
: V00.30 / 765D
: V00.20 / 10A9
: V10.00
-> No click
-> 1 click
-> 2 clicks
-> 3 clicks
-> 5 clicks
-> 6 clicks
6-1
6.1 OFFLINE DIAGNOSTIC
This menu appears when option interface
card (RS232 or Ethernet) is installed.
Advertisement
