Copying From The Paper Bypass - Ricoh 480W Operating Instructions Manual

E E E E
Press the { { { { Interrupt} } } } key again.
The Interrupt key indicator goes off.
Resuming the previous copy job
A Place your originals, and then
press the { { { { Start} } } } key.
Exiting interrupt copy
A Press the { { { { Clear Modes} } } } key.
Copying from the Paper
Bypass
Use the paper bypass to copy onto pa-
per sizes that cannot be loaded on the
paper rolls, or cut sheet paper.
Preparation
When copying from the paper by-
pass, you can make multiple cop-
ies for a single original. Specify the
number of copies using the num-
ber keys.
Limitation
❒ The maximum length is 2000 mm
(78").
❒ The width for paper in the paper
bypass is 210 – 914 mm (8
❒ Do not copy on both sides of the
paper.
❒ Do not use paper already copied or
printed on.
Reference
For details about paper type, ori-
entation, and number of sheets
that can be placed in the paper by-
pass, see "Copy Paper", General
Settings Guide.
You can specify the paper type for
the paper bypass in advance. See
"Paper Type: Bypass Tray", Gener-
al Settings Guide.
A A A A
Press [Bypass].
B B B B
Make the necessary settings.
C C C C
Enter the number of copies using
the number keys.
D D D D
Place your original and scan it.
1
/ " – 36").
2
E E E E
Adjust the paper bypass's paper
guides to the size of the paper.
Reference
See explanations of each func-
tion.
Reference
p.15 "Placing Originals"
Basic Procedure
2
AHD054S
AGL058S
25