Troubleshooting; If Your Machine Does Not Operate As You Want; When A Message Appears - Ricoh 480W Operating Instructions Manual

If Your Machine Does Not Operate As You
Want

When a Message Appears

The following chart contains explanations of common messages. If other mes-
sages appear, follow the instructions displayed.
Message
Please wait.
Check paper size
Check original ori-
entation.
Memory is full.

3. Troubleshooting

Problem/Causes
The main power has just been
turned on, paper type (plain
paper/translucent pa-
per/film) was changed, or the
machine is otherwise getting
ready.
An improper paper size is set. Select paper manually, do not
In User Auto Reduce/En-
large, the original is set to L.
In User Auto Reduce/En-
large, the original is set to K.
The machine's memory is full
due to scanning originals or
performing a function. The
number of originals that can
be stored in memory depends
on the size of originals and
function settings.
Solutions
Wait for the machine to fully
warm-up.
Note
❒ When "
Scanning
originals can be
" and "
started. Se-
lect copy mode and
Place original
displayed alternately, you
can make the settings for
your copies and scan your
originals. After the origi-
nals have been scanned,
the machine will automati-
cally start copying after it
has warmed-up. See p.23
"Auto Start".
use Auto Paper Select.
For User Auto Reduce/En-
large, set the original to K.
For User Auto Reduce/En-
large, set the original to L.
• When Sort is selected,
press [Exit] to copy
scanned originals, and
then copy remaining origi-
nals.
• When the Job Preset func-
tion is selected, check the
number of preset jobs, and
then try scanning the orig-
inals again.
" are
67