Troubleshooting When Using The Ddst Unit; The Printer Function; When A Message Is Displayed - Ricoh Aficio MP161 Troubleshooting Manual

6. Troubleshooting When
This chapter describes likely causes of and possible solutions for printer and
scanner function problems when using machines with the DDST Unit.

The Printer Function

When a Message Is Displayed

This section describes the principal messages that appear on the display panel.
If a message not described here appears, act according to the message.
Reference
Before turning the main power off, see "Turning On the Power", About This
Machine.
❖ Status messages
Message
Ready
Printing...
Waiting...
Offline
Please wait...
Resetting Job...
Setting change...
❖ Alert messages
Message
Change Tray # to the
following settings:
xxx yyy
Collate cancelled.
Using the DDST Unit
The machine is ready for use. No action is required.
The machine is printing. Wait a while.
The machine is waiting for the next data to print. Wait a while.
The machine is offline. To start printing, switch the machine on-
line by pressing {Online} on the control panel.
Wait a while.
The machine is resetting the print job. Wait until "Ready" ap-
pears on the display.
The machine settings are being changed. Wait a while.
Cause
The settings of the selected pa-
per tray are different from
those specified for printing.
# indicates the tray number.
xxx indicates the tray number.
yyy indicates the paper size.
The collate print function has
been canceled.
Status
Solution
Press [JobReset] to change the
paper tray settings, or press
[FormFeed] to print regardless.
For details about the paper
tray settings, see "Tray Paper
Settings", General Settings
Guide.
Turn the main power switch off,
wait a few seconds, and then
turn it back on. If the message
appears again, contact your
sales or service representative.
65