Ricoh Aficio 240W Copy Reference Manual page 80

Troubleshooting
Message
Out of specified pa-
per
Load ***mm width pa-
per
Check settings
Cannot rotate sort
3
this size orig.
Set other original,
or press[Change] and
cancel rotate sort.
Max. Copy Quantity:
NN
Some settings cannot
be changed. Press
[Re-scan] and reset
original to copy
with current set-
ting.
Open the part as
shown and remove
original.
Open the part as
shown and remove pa-
per.
Open the Rear Cover
and remove paper.
70
Problem/Causes
The ratio set in Auto Paper Se-
lect is different to the size of
the copy paper size.
Copy paper size and original
size is different.
The scanned original is too big
to rotate.
An unsuitable paper size for
rotate sort has been set.
The number of copies exceeds
maximum.
Function that cannot be
changed are set in Additional
Copy.
The original has jammed
(original misfeed).
The copy paper has jammed.
Solutions
• Check the settings for Re-
duce/Enlarge, etc., and
then try again.
• Set paper of a suitable
width.
Check the settings for Re-
duce/Enlarge, etc., and then
try again.
You cannot use rotate sort
with A0 (E) originals.
Set paper of the following di-
mensions: A2 594 × 420 mm,
A3 420 × 297 mm.
❖ ❖ ❖ ❖ Inch version (Engineer-
ing)
• 11" × 17"
• 17" × 22"
• 22" × 34"
❖ ❖ ❖ ❖ Inch version (Architec-
ture)
• 12" × 18"
• 18" × 24"
• 24" × 35"
Change the maximum copy
quantity you can make at a
time. See p.86 "Max. No. of
Sets".
Check the settings, and then
use Additional Copy again.
Follow the on-screen instruc-
tions to remove the jammed
original. See "xClearing Mis-
feeds", General Settings Guide.
Follow the on-screen instruc-
tions to remove the jammed
paper. See "xClearing Mis-
feeds", General Settings Guide.
DRAFT 2003/11/12