Hoover HIES854MB1TT Instruction Manual page 27

A(mm) B(mm)
760 50 mini
Before you install the hob, make sure that
the work surface is square and level, and no structural members interfere with
space requirements
the work surface is made of a heat-resistant material
if the hob is installed above an oven, the oven has a built-in cooling fan
the installation will comply with all clearance requirements and applicable
standards and regulations
a suitable isolating switch providing full disconnection from the mains power
supply is incorporated in the permanent wiring, mounted and positioned to
comply with the local wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm air gap
contact separation in all poles (or in all active [phase] conductors if the local
wiring rules allow for this variation of the requirements)
the isolating switch will be easily accessible to the customer with the hob
installed
you consult local building authorities and by-laws if in doubt regarding
installation
you use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the
wall surfaces surrounding the hob.
When you have installed the hob, make sure that
the power supply cable is not accessible through cupboard doors or drawers
there is adequate flow of fresh air from outside the cabinetry to the base of the
hob
if the hob is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the hob
the isolating switch is easily accessible by the customer
C(mm) D
20 mini Air intake
EN-26
E
Air exit 10 mm