Vertical Bi-Amplified Connections - REVELL Ultima Gem Owner's Manual

VERTICAL BI-AMPLIFIED CONNECTIONS

Vertical bi-amplified connections are made between both pairs of
Salon2/Studio2 input terminals and two separate power amplifier
output channels. Each speaker is connected to its own power
amplifier. The power amplifiers must be identical. Vertical
bi-amplified connections are shown in Figure 10.
Note
When making vertical bi-amplified connections, both power
amplifiers must receive identical input signals from the associated
preamplifier. A "Y" adaptor is required if the associated preamplifier
does not offer two connectors per output channel. Otherwise, each
power amplifier can be connected to a separate connector for the
same output channel of the preamplifier.
To make vertical bi-amplified connections:
1. Remove the jumper straps identified in Figure 4, page 9.
2. Connect one pair of loudspeaker wires to the high frequency
pair of Salon2/Studio2 input terminals. Then connect the
same pair of loudspeaker wires to the desired power amplifier
output channel.
3. Connect another pair of loudspeaker wires to the
low-frequency pair of Salon2/Studio2 input terminals. Then
connect the same pair of loudspeaker wires to a separate
output channel on the same power amplifier.
4. Make sure that all terminals are firmly hand-tightened.
Note
Vertical bi-amplified connections must be made using two identical
power amplifiers.
Ultima Salon2/Studio2
Owner's Manual
Figure 10: Vertical Bi-Amplified Connection
Contour
Normal Boundary
STUDIO2
POWER
AMPLIFIER 1
OUTPUT 2 OUTPUT 1
17