Table of Contents
Advertisement
Installing the power button with fingerprint reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the installation
procedure.
Steps
1. Align the screw holes on the power button with fingerprint reader with the screw holes on the palm-rest and keyboard
assembly.
2. Replace the two screws (M2x3) that secure the power button with fingerprint reader to the palm-rest and keyboard
assembly.
Next steps
1. Install the
system
board.
2. Install the
hard
drive.
3. Install the
power-adapter
4. Install the
heat
sink.
5. Install the
right
fan.
6. Install the
WLAN
card.
7. Install the
solid-state drive/Intel
8. Install the battery.
9. Install the
base
cover.
10. Follow the procedure in
56
Removing and installing components
port.
Optane.
After working inside your
computer.
Advertisement
Table of Contents
