Table of Contents
Advertisement
ReplayTV5.5 UG.book Page 72 Friday, August 1, 2003 10:58 AM
14 Outdoor Antenna Grounding
product, be sure the antenna or cable system is grounded so as to provide some protection against volt-
age surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, pro-
vides information with regard to proper grounding of the mast and supporting structure, grounding of
the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-dis-
charge unit, connection to grounding electrodes, and requirements for the grounding electrode.
15 Lightning
For added protection for this product during a lightning storm, or when it is left unat-
tended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or
cable system. This will prevent damage to the product due to lightning and power lines surges.
16 Power Lines
An outside antenna system should not be located in the vicinity of overhead power
lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When
installing an outside antenna system, extreme care should be taken to keep from touching such power
lines or circuits as contact with them might be fatal.
17 Overloading
Do not overload wall outlets, extension cords, or integral convenience receptacles
as this can result in a risk of fire or electric shock.
18 Object and Liquid Entry
short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.
19 Servicing
Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer
all servicing to qualified service personnel.
20 Damage Requiring Service
conditions:
•
When the power-supply cord or plug is damaged,
•
If liquid has been spilled, or objects have fallen into the product,
•
If the product has been exposed to rain or water,
•
If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instruc-
tions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the
product to its normal operation,
•
If the product has been dropped or damaged in any way, and
•
When the product exhibits a distinct change in performance–this indicates a need for service.
21 Replacement Parts
turer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.
22 Safety Check
Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the
product is in proper operating condition.
23 Wall or Ceiling Mounting
24 Heat
The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that pro-
duce heat.
72
If an outside antenna or cable system is connected to the
Never push objects of any kind into this product through openings as they may touch dangerous voltage points or
Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following
When replacement parts are required, be sure the service technician has used replacement parts specified by the manufac-
The product should be mounted to a wall or ceiling only as recommended by the manufacturer.
Advertisement
Table of Contents
