Table of Contents
Advertisement
ReplayTV5.5 UG.book Page 5 Friday, August 1, 2003 10:58 AM
:: Rear Panel Overview
1
OUT TO TV
Connect to a television VHF/UHF jack with RF cable.
2
IN FROM ANT/CATV
3
VIDEO/AUDIO IN 1/IN 2
video cables.
4
S-VIDEO IN
Connect to a cable box or satellite receiver that has S-Video Out. The Audio IN 2 connectors must be used
with S-Video to receive sound. (Please note that S-Video In is part of Line 2.)
5
VIDEO/AUDIO OUT 1/OUT 2
dard audio/video cables.
6
PROGRESSIVE OUT
7
POWER CORD
8
S-VIDEO OUT
Connect to a television, monitor or A/V receiver that has S-Video In. (Please note that Video Out 1, Video
Out 2 and S-Video are active at all times.)
9
DIGITAL AUDIO OUT (OPTICAL)
10 SERIAL CONTROL
the satellite receiver. The IR Blaster is not needed if the satellite receiver supports serial control.
11 IR BLASTER
Connect and affix the IR emitter over the infrared detector on a cable box or satellite receiver. This allows
ReplayTV to change the channels on these devices.
12 NETWORK ACTIVITY AND LINK LIGHTS
light indicates that ReplayTV is connected to the network. The yellow light indicates network activity; i.e., data is being trans-
ferred to or from the unit.
Connect an antenna, cable TV RF cable, or cable box with RF cable.
Connect to the Audio/Video outputs of a cable box or satellite receiver using standard audio/
Connect to the Audio/Video inputs of a television, monitor or A/V receiver using stan-
Connect to a television, monitor or A/V receiver that has Progressive Video In.
Connect to an electrical outlet.
Connect to an audio/video receiver equipped with an optical input.
Connect to a satellite receiver that has a Serial port. This allows ReplayTV to change the channels on
Indicates the status of ReplayTV when using the Ethernet port. The green
5
Advertisement
Table of Contents
