WAGNER FLEXiO 590 Owner's Manual page 14

Cleaning the nozzle
To Clean the Nozzle:
1. Make sure power cord is unplugged.
Push the tab below the trigger, twist and separate the
nozzle from the turbine. Wipe the exterior of the cup and
nozzle until clean.
2. iSpray nozzle only -
a. Remove the adjustment ring (a) carefully from the
connecting nut (b). Loosen the connecting nut.
b. Remove the parts as shown. Clean all parts with a
cleaning brush and the appropriate cleaning solution.
To reassemble, see the instructions on the next page.
3. Detail Finish nozzle only -
a. Unscrew the nut and remove the air cap and nozzle.
Remove the parts as shown(*). Clean all parts with a
cleaning brush and the appropriate cleaning solution.
Reassemble all parts when clean(**).
4. Clean the air vent (c) on the suction tube with a soft
bristled cleaning brush.
5. Clean the rear of the nozzle (d) with the appropriate
cleaning solution. Use a thin layer of petroleum jelly to
lubricate the O-ring (e).
2b
5
© Wagner Spray Tech - All Rights Reserved
Cleanup (continued)
3a
Nozzle seal (Detail Finish nozzle only)
(*)
The nozzle seal may
become stuck inside the
(e)
Detail Finish nozzle when
the nozzle is removed. If this
occurs, make sure to pull it
out.
(d)
1
2a
(b)
(a)
4
(**)
It is important that the nozzle
seal inside the nozzle be re-installed
properly. Make sure the cup side of
the seal (the side with the groove) is
facing out towards the front of the
nozzle. Improper installation will cause
leakage and damage to the turbine.
Groove
English
(c)
13