Using With Raymarine Gps; Nmea Connections - Raymarine SmartPilot S1000 Installation Manual

26
Diagram D: NMEA connections
Course Computer
Data
cable
SeaTalk & safety
alarm
connections
(see Diagram C)

Using with Raymarine GPS

If a Raymarine GPS (such as the Raystar 120 or 125)
is to be connected to the S1000 Autopilot via NMEA,
the
NMEA in
correctly connected.
Each time power is applied to an S1000 Autopilot
connected to a Raymarine GPS (via NMEA or SeaTalk),
the S1000 will set the GPS filtering to WEAK.
NMEA Spur
CAUTION:
Before making any changes to the Data Cable,
disconnect it from the Course Computer.
If it is more convenient to connect the NMEA spur to the GPS
without using the NMEA connector, you can remove the
connector and prepare the cable end as appropriate for your
preferred method of connection. Refer to the wire identification
table below, as necessary
Wire Pin
color number
Brown 1
Green 2
Orange 3
Blue 5
When you have completed the electrical
connections, secure the wires at the
S1000 Autopilot Installation Guide
and and
out, +ve
NMEA
Connector
NMEA signal
at S1000
-- ve out
+ve out
+ve in
-- ve in
Course Computer.
lines must all be
-ve
Pin 1
Pin 2
Pin 3
Pin 5
Connection at
3rd party GPS
NMEA --ve receive
NMEA +ve receive
NMEA +ve transmit
NMEA --ve transmit