Raymarine Rudder Installation Manual page 5

4
Mounting
End
bracket
Starboard
Bullhorn
bolt
ram shaft
Nut and Threaded
washer rod
Sensor
U-bracket
shaft
Sensor
shaft
Alignment mark
1. Use the steering system to position the bullhorn ram amidships.
2. If necessary, release the hydraulic pressure from the boat's
hydraulic steering system
Note: Contact your steering gear manufacture for advice on this step,
and follow their instructions for releasing the hydraulic pressure.
3. Loosen the starboard bolt that secures the bullhorn ram's shaft to
the end bracket.
4. Fit the U-bracket (supplied) over the end bracket and the bullhorn
ram's shaft.
5. Hand tighten the starboard bolt to hold the U-bracket in place.
6. Fully open the hose clamps (supplied) using a flat bladed
screwdriver, then hang them over the bullhorn ram.
7. Place the spacers (supplied) on the bullhorn ram and use adhesive
tape to secure them temporarily.
8. Pull out the rudder sensor's shaft until its alignment mark is level
with the end of the barrel.
9. Position the rudder sensor against the spacers so the threaded rod
end of its shaft passes through the U-bracket.
Sensor
barrel
Sensor
barrel
Hose clamp
Linear Rudder Position Sensor
Spacer
Cable
Bullhorn
ram
D5390-1