Raymarine RayTech RNS 5.0 Getting Started page 41

Interfacing RNS
Integrated system checks
When RNS is installed on your PC and connections have been made to hsb
SeaTalk, carry out the following checks:
General
Power up the whole system including PC, hsb
navigation equipment that is connected to the system.
SeaTalk
1. Check GPS setup page on one of your Raymarine hsb
there is a FIX.
2. Select the chart screen on RNS and click
symbol is centered on the screen in the correct location. If it is not check all SeaTalk
connections.
3. Check Nav data (a half- screen data page) on a Raymarine hsb
show available SeaTalk data from instruments (wind, speed, depth, etc.) and auto-
pilot (heading, rudder position, pilot status, etc.).
4. Select suitable databoxes on RNS and ensure all SeaTalk data is displayed.
2
hsb
1. Check on one of your Raymarine hsb
radar, sonar) are available by pressing the DISPLAY button.
2. Set up RNS to show all of the same options as listed in 1. Make sure the radar and
sonar picture match from your hsb
connections.
3. Chart data an be shared via hsb
2
hsb
On the RNS chart page, turn raster charts OFF, and C-Map ON. Click the
button to zoom in and check that the chart data is correct.
display, check that the same cartography is displayed on RNS.
2
displays, instruments and any other
Find Vessel
. Make sure that the vessel
2
displays hat all the expected options (chart,
2
display to RNS. If they do not, check all hsb
2
. With a chart cartridge installed in a Raymarine
2
and
2
displays and ensure that
2
display. This should
RANGE
37
2