Raymarine RayTech RNS 5.0 Getting Started page 39

Interfacing RNS
Connecting to Ockam Instruments
RNS connects to Ockam instruments via the Ockam Model 050D RS-232 Interface (not
supplied). You must also set two switches on the Ockam unit.
You can connect RNS using any Ockam RS-232 interface, however for optimum
reliability of data transfer the Model 050D is recommended.
To connect to a Model 050D RS-232 interface:
1. On the interface, set switch
2. Set switch
3. Connect the cables as follows:
Cable color
Yellow (Rx)
Black (SGnd)
Green (Tx)
Black (SGnd)
Connecting a USB C-Card Reader
This section describes connecting a USB C-Card reader to your PC system.
To install a USB C-Card reader to your PC:
1. Plug your C-Map USB C-Card reader into your computer.
2. Click
3. Click
4. Click
5. Click Next. Follow the on-screen instructions.
S2
to D.
Ockam 050D pin
Pin 4
Not used
Pin 2
Pin1
Start
on the computer taskbar. The pop-up menu is displayed.
Control Panel
. The control panel is displayed.
Add/Remove Hardware
S1
to 4.
. The Add/Remove Hardware wizard is displayed.
35