HP NetServer LXr 8500 Installation Manual page 41

Chapter 4
Figure 4-3. Attaching the Slides to HP NetServer Chassis
3. Line up the mounting holes in the slide members with the holes in the HP
NetServer chassis, insert the four screws on each side and tighten them, as
shown in Figure 4-3.
4. Remove the two screws from each of the four lifting handles and remove
the handles, as shown in Figure 4-4. Keep these handles and screws for
later use, in case you need to remove the HP NetServer and ship it.
36
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Figure 4-4. Removing Lifting Handles
Installing into the Rack