HP NetServer LXr 8500 Installation Manual page 25

Chapter 2
3. Grasp the LCD assembly with both hands. Pull up firmly on the LCD
assembly to lift it as high as possible. You may need to pull quite firmly
and wiggle the LCD assembly to overcome the retaining spring shown in
Figure 2-11.
When the LCD assembly is lifted high enough, the upper two posts on the
HP NetServer are in the wide part of the upper two slots on the LCD cover,
and the lower posts are free. When you feel that looseness, gently pull the
LCD assembly away from the NetServer. Be careful not to damage the
LCD cables.
Retaining
Spring
Rear Half
of Existing
LCD Cover
Ribbon Cable
4. Gently pull the LCD cables out through the hole in the processor tray.
5. To disassemble the LCD cover, gently push the face of the LCD into the
LCD cover, as shown in Figure 2-11. The front half of the LCD cover
detaches completely from the LCD board. Discard the front half of the
LCD cover, but retain the LCD board.
6. Gently slide the LCD cables through the rear half of the LCD cover, as
shown in Figure 2-11. Discard the rear half of the LCD cover, but retain
the LCD board.
20
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Slots for Posts on
Front of HP NetServer
(4 Places)
Twisted-Pair Cable
LCD Board
Front Half
of Existing
LCD Cover
Figure 2-11. Disassembling the Existing LCD Assembly
Preparing the HP NetServer
LCD