Atag VA6611QT Use & Care Manual page 40

Step 4. Connecting electricity, water and drain
1. Connect Connect drain hose
The drain hose runs to an inlet plug on the
ink unit's water trap.
Note:!
The hose must be fastened on a level with the
underside of the sink unit.
Cut the drain hose adapter to the appropriate
size for connection to the undersink drain or gar­
bage disposer. The overall length of the drainage
hose must not exceed 4,5 m.
No part of the drainage hose may be more than
950 mm above the bottom of the dishwasher.
The hose must not be run directly to the floor
drain or similar.
The hose must always discharge at least 350
mm above the bottom of the dishwasher.
2. Connect water supply hose
ConnecUse the supplied O ring and tighten
the connection by hand plus a quarter turn
with a wrench. Open the shutoff valve and
let the pressure settle for a while. Check the
connections again to make sure they are not
leaking.
3. Connect the electric plug
Ensure that the power socket is within the
range of the power cable. Do not use an
extension cord! The dishwasher must be con­
nected to a grounded outlet.
0
Connection pipe
Shut
off
valve
Clamp
Hose barb
coupling
Water connection