Rangemaster Toledo XT Electric Users Manual & Installation page 27

WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
to the control panel by fi rst lining up the raised key on its
body with the cut-out in the control panel and pushing it
in from the front. Assemble the new switch to the bezel
by lining up the key sections and pushing home. Fit the
new button by pushing in from the front.
Replace control panel in reverse order and test for
correct operation.
6. To Remove Electronic Timer
Disconnect from electricity supply.
Pull off the timer control buttons and remove the control
panel (See 4). Remove the timer/mounting bracket
assembly from the control panel by removing the two
fi xing screws. Remove the timer from its mounting
bracket by depressing the plastic lugs on the timer case,
at the same time pulling the unit forward.
Reassemble in reverse order. When replacing leads refer
to the wiring diagram. Check operation of timer
7. To Change Hob Controller
Lift up the ceramic hob top (see 2). Remove control
panel (see 4). Disconnect wiring from controller. Remove
2 screws holding controller to mounting panel. Fit new
controller and reassemble in reverse order. Check for
correct operation.
8. To Remove a Thermostat
Disconnect from the electricity supply.
Lift up the ceramic hob top (see 2). Remove control
panel (see 4). Open appropriate oven door and remove
oven furniture.
RH oven
Remove the two fi xings that secure the thermostat phial
cover. Unclip the thermostat phial from the clips in the
oven back panel.
LH oven
Remove the two screws holding the thermostat phial
to the oven fan cover at the rear of the oven. Pull the
unit forward to access the rear of the cooker. Remove
the both cover boxes by removing the fi xing screws
and lifting clear. Feed the thermostat capillary clear of
the oven. Disconnect the wires from the thermostat
and undo the two fi xings that secure the control to the
mounting plate. Fit the replacement and re-assemble in
reverse order. Ensure that the phial is clipped to the oven
rear, positioned centrally between the clips.
Check that the thermostat functions correctly.
9 To Remove an Oven element Thermal Cut-Out.
Disconnect from the electricity supply.
Pull the cooker for ward to gain access to the cover
box. Undo the cover screws and lift clear. The cutout
is located on the earth plate be side the oven element
con nec tions. Disconnect the cutout wir ing. Undo the
fi xings that secure the cutout to the earth plate and
re move. Fit re place ment control and re-as sem ble in
reverse order.
10. To Remove an Oven Door
Open oven door. Support the door and remove the
two screws securing the upper hinge and gasket to the
cooker front. Remove the door from the lower hinge by
lifting slightly and moving outwards.
Reassemble in reverse order.
11. To Change Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel
fi xing screws from the door sides (two each side).
Carefully lift off the outer door panel.
Remove door handle from panel by unscrewing 2
retaining nuts. Fit door handle to new panel
Fit panel to door. Reassemble in reverse order.
12. To Change Oven Door Latch
Remove outer door panel (see 13). Remove screws 'B'
holding latch assembly to inner door panel. Fit new
catch and reassemble in reverse order.
Check correct door operation.
27