ICON Health & Fitness Pro-Form Cadence LT2.5 User Manual page 11

8. Connect the Upright Wire (67) to the con-
sole wire (B). The connectors should slide
together easily and snap into place. If they do
not, turn one connector and try again.
Insert any excess wire into the console
assembly (A).
9. Identify the Right Handrail Top (61). Set the
Right Handrail Top on the Handrail (63) and
slide it forward against the console assembly
(A). Attach the Right Handrail Top with two #8 x
3/4" Screws (3). Note: The Screws need to be
inserted at an angle as shown. Be careful not
to overtighten the Screws.
Slide the Right Handrail Bottom (62) upward.
Make sure that the Upright Wire (67) is cov-
ered by the Right Handrail Bottom and is not
pinched. Attach the Right Handrail Bottom with
a #8 x 3/4" Screw (3) and three #8 x 1/2" Screws
(81) as shown. Be careful not to overtighten
the Screws.
Attach the Left Handrail Top and Left
Handrail Bottom (not shown) as described
above. Note: There are no wires on the left side.
8
A
B
67
9
61
63
62
11
A
67
3
81
3