How To Affix The Ferrite Core - LG S65S3-S Owner's Manual

How to Affix the Ferrite Core

Ferrite core may not be provided depending on each
nation' s regulations.
Affix the Ferrite Core for speaker
cables
You must affix a ferrite core in order to reduce or
eliminate electrical interference.
1. Pull the stopper [a] of the ferrite core to open.
2. Wind the speaker cables around the ferrite core
twice.
3. Close the ferrite core until it clicks.
,
Note
y If there is a strong electromagnetic wave
product nearby, interference may occur. Put
the main unit and wireless receiver away from
there.
y The wireless receiver will automatically switch
to standby mode in a few minutes after the
sound bar is turned off.
When the wireless reciever is in standby
mode, the LED will turn on in red.
y When you turn on the sound bar, the wireless
receiver will turn on and the LED will change
to yellow - green and then the rear speakers
makes sound within a few seconds.
y It takes a few seconds (and may take longer)
for the main unit and Wireless Receiver to
communicate with each other.
y Use the rear speaker at least 30 cm away
from either TV screen or PC monitor.
y When the wireless receiver is being
connected or disconneced with the main unit,
output sound is maybe interrupted.
y Set the distance between the sound bar and
the wireless receiver as close as possible and
keep them away from the device (ex. wireless
router, microwave oven, etc.) over
1 m to prevent wireless interference.
Connecting 19
2