Bauknecht GSU 5639 Quick Reference Manual

GSU 5639
Programme selector knob
On / Off button
Start button
Switches "on" when the dishwasher is operating.
Flashes when a fault occurs. Switches off at the end
of the programme.
Indicators
Add regeneration salt
Only add regeneration salt immediately before
starting a wash programme.
Add rinse aid
Programme chart
Programmes
Pre-Rinse
Glass
Quickwash
1) 5) 6) (*)
Bio
5) (*)
Standard
5)
Intensive
1) Reference programme for energy label in compliance with
EN 50242 regulations;
2) Refer to "User instructions";
3) Programme data obtained in conformity with European
standard EN 50242. Values may vary in relation to usage,
e.g.: different loads, options, water temperatures - above
or below 15°C - as well as water hardness and power
supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
Before using the dishwasher, read the user instructions!
Quick Reference Guide
Loading instructions
cold
Crockery to be washed later.
Light soiling, for example glasses and
40°C
cups.
Lightly soiled crockery with no
40°C
dried-on food.
50°C
Normally soiled crockery.
60°C
Normally or heavily soiled crockery.
Recommended programme for
70°C
heavily soiled crockery, especially
suitable for pans and saucepans.
3)
Options
Time and failure display
Indicates in hours the time remaining until the start
of the wash cycle. Switches off when the
programme starts and indicates the time remaining
in hours and minutes.
"F ...." Identification of faults for service technician
"Delayed start" button
The wash cycle can be programmed to start after
1 - 24 hours. With each successive touch of the button,
the delayed start indicator increases by 1 hour, and
after 24 returns to 00. Then press the Start button.
The dishwasher will start at the set time.
Antibacterial rinse
This function adds an antibacterial rinse at the end of
the wash cycle, thereby guaranteeing a perfectly clean
and sanitized load. The lamp will light up when the
function is activated. If the temperature is not
maintained during the antibacterial cycle (e.g. if the
door is opened and remains open for a long time), the
lamp will start blinking to indicate that sanitation is
not guaranteed.
"Half Load" button
Possibility of only half loading the top and bottom
1
racks. Select the required programme then press
2
the "Half Load" button. The light comes on and
goes off at the end of the programme.
The "Half Load" function can be used with
programmes marked with an *.
Detergent
A B
- -
X -
X -
X X
X X
X X
4) The bacteria removal efficiency has been tested by the
Institut Pasteur de Lille (France), based on the NF
EN 13697 standard of November 2001.
5) These programmes can be used with the Antibacterial
rinse option.
6) Energy saving programme with prolonged drying cycle.
(We reserve the right to make technical modifications)
GB
4)
2) 3)
Consumption
Litres kWh Minutes
5.0 0.02 10
13.0 0.90 97
13.0 0.70 30
16.0 1.05 195
16.0 1.35 120
17.0 1.65 145
5019 496 90460