Cycles, Options And Lights - Kenmore 465.1334 Series Use & Care Manual

C
YCLES
Indicator Lights on Control Panel
See page 5 for all model indicator lights.
INDICATOR
Delay Hours
Start/Resume
Cancel/Drain
Sanitized
(select models)
Clean
(select models)
Rinse-Aid Low
Notes:
• When the Anti-Bacterial (select models), Smart Sense
(select models) is selected, the final rinse cycle is monitored to assure sanitization. The Sanitized light will not
illuminate if sanitization requirements are not met. This could happen if the cycle is interrupted, power failure
occurs or incoming water temperature is below 120° F (49° F).
• The Clean and Sanitized indicator lights will not relight after a power failure until after the next cycle is run.
All manuals and user guides at all-guides.com
, O
PTIONS AND
Only the indicator light for the currently selected delay setting will be illuminated during a
delay selection. For example, if a 4 hour delay is selected, the 2 hour and 8 hour delay
indicator lights will not be illuminated (see page 13 for operation of the Delay Hours option).
The Start/Resume indicator light, located on the top of the drawer, will be illuminated while the
dishwasher is executing a cycle or delay whether or not the drawer is open. The Start/Resume
indicator light will not illuminate in any other mode. If the drawer is opened during a wash
cycle, the Start/Resume indicator light will flash until it is pressed to restart the cycle.
The Cancel/Drain pad will illuminate to indicate that a cancel initiated drain is running.
Illuminates at the end of the cycle when conditions have been met to achieve sanitization.
The light will remain lit until the drawer has been open for 30 seconds continuously.
The clean indicator light, located on the control panel, will illuminate as soon as any
cycle except Quick Rinse is completed.
Illuminates when the rinse aid dispenser is low or empty and the drawer is open.
L
DESCRIPTION
™ (select models) or Normal Wash cycle with Sani-Rinse
14
IGHTS