Table of Contents
Advertisement
Meter Setup Before Use
Battery Installation
Your
Blood Glucose Meter requires the CR 2032 3.0V coin
cell battery. You can find two in the carrying case. Please follow the steps
below for installation:
1.
Turn the meter to the back side, press to open the battery cover as
shown in the picture.
2.
Insert the battery. Make sure that the positive side (+) is facing up.
3.
Replace the battery cover, making sure that it is closed tightly.
CAUTION: Please follow the local regulation to properly discard a used battery.
Setting Up Your Meter
Follow the steps below to set up your meter:
System Settings
Before using your meter for the first time, make sure all system settings
are correct. For example, setting the correct time is essential for the
history function to work properly.
Press the "<" button for 2 seconds to enter the system settings menu.
Date and Time Settings
1. The display will show the month, day, and year. In the upper right
portion of the screen, the year will flash. Press the "<" or ">" buttons to
change the year, and then the "M" button to save your choice.
Month Day
Year
Month Day
Time
8
2. The display will now show the month and day in the top left corner.
Change the month and day by pressing the "<" or ">" buttons. Press
"M" to save.
3. Next, set the correct time. By default, the meter will show the time
in 24 hour display mode. Press "M" to save the correct time. The meter
will now allow you to change to either 24 hour or 12 hour display mode
by pressing "<" or ">". Press "M" to save and continue to the next step.
Audio Settings
You can turn your meter's sound on and off in the audio settings menu.
Press "<" or ">" to turn the sound on or off. Press the "M" button to save
this setting.
or
When the sound is on, the meter will provide a beep when:
a. The meter is powered on
b. The blood sample is adequate
c. The test results are displayed
You will hear a one beep warning sound when the meter is powered on,
if the blood sample is adequately applied, and when the test results are
displayed. You will hear 2 short beep warning sounds if an error occurs.
Please refer to the error code table included in this instruction manual.
After you have chosen the audio setting, the meter will enter the high and
low blood glucose alarm settings.
or
d. An error occurs
e. A test reminder alarm is activated
9
Advertisement
Table of Contents
