Table of Contents
Advertisement
46
en | Installing the In-Ceiling Mount
3.7
Attach Housing to the Interface Box
The In-Ceiling Housing is attached to the Interface Box and secured by two (2) thumbscrews.
Fig. 3.10 Attach Housing to Interface Box
1.
Insert the In-ceiling housing through the hole in the ceiling to verify that the edge of the
hole support the unit. Then remove the housing from the hole.
2.
Align the ball studs of the In-Ceiling Housing to the Stud Retainers on Interface Box and
attach.
3.
Tighten the two (2) Thumbscrews to secure the Interface Box to the housing.
In-ceiling
Housing
Fig. 3.11 In-Ceiling Housing and Interface Board
CAUTION! The In-ceiling dome is provided with tether points on each side of the housing. To
!
prevent injury, attach a safety wire from a secure anchor point above the ceiling to a tether
point on the dome housing, see Figure 3.12 on page 47 for an illustration of this process.
F01U010921 | 1.0 | 2006.10
Interface Box
Installation Manual
AutoDome Modular Camera System
Ball Stud
Retainer
Thumb Screw
Ball Stud
Tether Point
Ceiling Clamp
Bosch Security Systems, Inc.
Advertisement
Table of Contents
