Table of Contents
Advertisement
AutoDome Modular Camera System
1.6
Make Connections in Power Supply Box
Refer to Figure 1.5 on page 9 to locate the various connectors in the power supply box and
make the following connections detailed below.
Fig. 1.7 Pendant Arm connections to Power Supply Box
1.
Attach the earth ground wire to the grounding screw on the left side of the power box.
2.
Connect the 6-pin Control In/Out Plug, installed previously, to its mating connector P106
in the power box. If this product is a Fiber Optic model this step is not required, since all
control data is sent through the fiber cable.
3.
Connect the 6-pin Control to Dome Plug from the Pendant Connector Harness to its mat-
ting connector P105 in the power box. (For Fiber Optic model connect to the P106 con-
nector.)
Fig. 1.8 Pendant Arm Harness Connectors
WARNING! Do not connect the RJ45 connector unless using UTP video or Ethernet.
!
4.
Connect the 5-pin, 24 VAC to Dome Plug from the Pendant Connector Harness to its cor-
responding color mating connector P107 on the right side of the box.
5.
Connect the incoming video coax cable to the BNC connector from the Pendant Connec-
tor Harness and slide its plastic cover over the connector.
Bosch Security Systems, Inc.
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 11
1 2 3
Control Data
CONTROL DATA
Coax Video
COAX VIDEO
24 VAC Power
24 VAC POWER
UTP/Ethernet Video
UTP/ETHERNET VIDEO
Installation Manual
Alarm Inputs
ALARM INPUTS
Alarm Outputs
ALARM OUTPUTS
Relays
RELAYS
F01U010921 | 1.0 | 2006.10
Advertisement
Table of Contents
