Husqvarna AUTOMOWER 550 Operator's Manual page 25

In the Operation's menu it is possible to change the
settings of the Weather timer, ECO mode and Spiral
cutting .
3.11.2.1 Spiral cutting
If the product enters an area where it senses the grass
is longer than average, it can change the movement
Spiral cutting . This means that the product
pattern to
mows in a spiral pattern to faster cut the area with
longer grass. It is possible to set the intensity of the
Spiral cutting . Very low / Low intensity means that Spiral
cutting begins less often. High / Very high intensity
means that Spiral cutting begins more often.
Note:
Spiral cutting is only started in the Main area
Secondary area mode does not let
mode. Cutting in the
the product to start Spiral cutting . Spiral Cutting does not
start in slopes steeper than 15%.
Settings > Operation in the app.
1. Select
2. Select On/Off to enable or disable Spiral cutting .
Settings > Spiral Cutting > Use > Intensity
3. Select
to select the level of the function.
Save .
4. Select
3.11.2.2 Weather timer
Weather timer automatically adjust the cutting time to
the growth of the grass. The product is not permitted to
operate more than the schedule settings.
Note:
Weather timer , it is recommended
When using
to make as much operating time as possible available
Weather timer . Do not restrict the schedule more
for
than necessary.
The first operation of the day is set by the schedule
settings. The product always complete 1 mowing cycle,
and then Weather timer selects if the product will
continue to operate or not.
Note:
Weather timer is reset if the product does not
operate for more than 50 hours, or if a
1439 - 007 - 07.01.2021
settings is done. Weather timer is not changed if a Reset
of schedule settings is done.
To set the Weather timer
1. Select
2. Select
timer .
Note:
the cutting time can be adjusted. Set the cutting
time
a shorter time.
3. Select
3.11.2.3 ECO mode
If ECO mode is activated, it switches off the signal in the
boundary loop, the guide wire and the charging station,
when the product is parked or is charging.
Note:
interference with other equipment, for example hearing
loops or garage doors.
Note:
push the STOP button before you remove the product
from the charging station. If not, the product can not be
started in the work area.
To set the ECO mode
1. Select
2. Select
function.
3. Select
3.11.3 Installation
In the Installation menu it is possible to adapt the
settings of the product for best mowing result.
3.11.3.1 To find the charging station
The product can be set to search for the charging station
in 3 methods:
• Charging station signal
Follow boundary wire
•
Follow guide wire
•
The factory setting is set to use the 3 search methods at
the same time. Use the factory setting to find the
charging station as fast as possible and to keep the risk
Reset of all user
of tracks on the lawn to a minimum. The product always
starts to search for the
Settings > Operation in the app.
on/off to enable or disable the Weather
If the cutting results are not satisfactory,
High to cut for a longer time or Low to cut for
Save .
ECO mode to save energy and avoid
Use
To start the product manually in the work area,
Settings > Operation in the app.
on/off to enable or disable the ECO mode
Save .
Charging station signal . After a
Installation - 25