Auto · Dry · Cool · Heat · Fan Operation - Daikin Perfera FTXTM-M Operation Manual

AUTO · DRY · COOL · HEAT ·
FAN Operation
NOTE
MODE
• Since this unit heats the room by taking heat from outdoor air to indoors, the heating capacity becomes smaller in lower
outdoor temperatures. If the heating effect is insuffi cient, it is recommended to use another heating appliance in combination
with the unit.
HEAT • The heat pump system heats the room by circulating hot air around all parts of the room. After the start of HEAT operation,
it takes some time before the room gets warmer.
• In HEAT operation, frost may occur on the outdoor unit and lower the heating capacity. In that case, the system switches
into defrosting operation to take away the frost.
• During defrosting operation, hot air does not fl ow out of indoor unit.
• This unit cools the room by releasing the heat in the room outside.
COOL
Therefore, the cooling performance of the unit may be degraded if the outdoor temperature is high
• The computer chip works to rid the room of humidity while maintaining the temperature as much as possible. It automatically
DRY
controls temperature and airfl ow rate, so manual adjustment of these functions is unavailable.
• In AUTO operation, the system selects an appropriate operation mode (COOL or HEAT) based on the room and outside
AUTO temperatures and starts the operation.
• The system automatically reselects setting at a regular interval to bring the room temperature to user-setting level.
FAN • This mode is valid for fan only.
The unit operates with the operation mode of your choice.
From the next time on, the unit will operate with the same operation mode.
■
To start operation
1.
Press
• Each pressing of the button advances the mode setting in sequence.
AUTO
2.
Press
• " " is displayed on the LCD.
• The OPERATION lamp lights green.
Display
■
To stop operation
Press
• " " disappears from the LCD.
• The OPERATION lamp goes off.
Notes on each operation mode
and select an operation mode.
DRY COOL
.
again.
HEAT FAN
12