Advertisement
Available languages
Available languages
CALL-WAY
03895
Remote assistance interface.
The remote assistance interface monitors the state of a wired input,
which can be configured as normally open (default) and normally
closed. The closing (or opening) of the contact sends an emergency
message to the hands-free unit art. 03980 to call the remote
assistance. The device also communicates the battery status (flat
and/or poor reception). The device has a tamper-proof micro-switch
to protect it from removal and/or opening. To receive the appropriate
signals, at least one telephone number must be configured for
the supervision of the connected accessories; for details see the
instruction sheet of the hands-free unit art. 03980.
OPERATION AND CHARACTERISTICS
LED
• When the battery charge level is low, whenever the contact is
activated the LED flashes for 2 seconds.
• When the device is opened and/or the tamper-proof device is
activated, the LED flashes for 2 seconds. If the condition persists,
the LED flashes for 2 seconds whenever the contact is activated.
• When the device is in learning mode, the LED flashes whenever the
contact is activated.
• When the battery is flat, the device stops sending messages and the
LED flashes every 4 seconds.
Extension terminals
The terminals are used to connect an external device with normally
closed or open clean contacts. The opening or closing of the contact
sends a message to the hands-free unit art. 03890 which makes
the call.
To connect the extension terminals:
1. Open the cover on the interface by unscrewing the screw on the
base.
2. Using a tool, remove the front of the cover to access the extension
terminals.
3. Connect the device to the terminals.
Knockout
49401858A0 01 2302
Battery
• The interface is powered by a CR123 3 V lithium battery. N.B. The
battery must always be replaced by another with the same size and
voltage.
• The interface reports if the battery is flat. If the charge status is
low, a diagnostic message is sent to inform of the condition. If the
interface is activated and the battery level is low, the LED flashes
whenever the contact is activated. If the battery is flat, the device
stops sending messages and the LED flashes every 4 seconds.
• When the flat battery is removed, press the tamper-proof push
button twice before inserting the new battery.
Tamper-proof protection
The interface is protected from tampering. If the accessory is opened
and/or moved from the place of installation, the switch is activated
and an alarm signal is sent to the hands-free unit. N.B. At least one
telephone number for the supervision of the accessories must have
been configured in the hands-free unit.
DEVICE START-UP
• Open the interface cover and insert the battery.
• Set the hands-free unit to learning mode (see the instruction sheet
for art. 03980).
• Press the test push button on the remote assistance interface.
• To complete the learning process, see the instruction sheet for art.
03980.
INSTALLATION
• The remote assistance interface must be installed on the wall or in
a junction box. In both cases, it must be fixed to the wall to close
the tamper-proof contact.
• Do not install the installation on metal surfaces.
REGULATORY COMPLIANCE
Directive RED. Directive RoHS.
Standards EN 301 489-3, EN 300 220-3-2, EN 50130-4, EN 62368-
1, EN 62479, EN IEC 63000.
Vimar SpA declares that the radio equipment complies with Directive
2014/53/EU. The full text of the EU declaration of conformity is on
the product sheet available on the following website: www.vimar.com.
REACH (EU) Regulation no. 1907/2006 – Art.33. The product may
contain traces of lead.
Viale Vicenza, 14
36063 Marostica VI - Italy
www.vimar.com
Advertisement
