C4 Panel; C4 Rear Panel Connections; C4 Loose Instruments; Starter Switch - Nanni N4.65 Operator's Manual

S05 INSTRUMENTS

C4 PANEL

C4 REAR PANEL CONNECTIONS

Nanni assembled panels are plug and play directly to the
engine via an extension cable.

C4 LOOSE INSTRUMENTS

STARTER SWITCH

This device allows to start and to stop the engine.
On/Stop : This button allows to connect the system
voltage and to stop the engine
Start : To preheat the engine, push the button halfway for
10 to 20 seconds depending on the outside temperature.
To start the engine, push the button fully.

COOLANT TEMPERATURE

This warning lamp comes on and the alarm sounds
when the coolant temperature is too high.
DANGER !
Never open the coolant filler cap or any plug of the
cooling system when the engine is warm. Steam or hot
fluid can spray out.
CAUTION !
If this alarm comes ON while operating the engine, stop
the engine, exept in extreme emergencies. Wait for the
engine to cool down. Check the coolant level, the belt
condition, the raw water filter, and if the sea cock is open.
To operate an engine when temperature is too high
can lead to a severe engine damage. Do not operate
the engine if the problem persist and contact a Nanni
representative as soon as possible.

BATTERY CHARGE

This warning lamp comes for a short time when the
electric system is turned on.
Should this lamp comes on when the engine is running,
this indicates that the alternator is not charging.
30