Engine Start - Nanni N4.65 Operator's Manual

S07 STARTING & RUNNING

ENGINE START

With key Type 4 :
1. Move the control lever to the neutral position.
ASTERN
2. Insert the key in the ON/STOP starter switch.
3. Turn the key a quarter-turn to the right (on C4 and A4
panel). All the warning lamps come on and the acoustic
alarm sounds. After a few seconds, only the engine oil
pressure and Battery charge lamps do lit.
On Eco 4, only the oil pressure and battery charge lamp
light on.
START
STOP STARTING
NEUTRAL
AHEAD
BEEP
4. Press the Start button halfway (position 1/2) to
start preheating. Hold the button for 10 to 20 seconds,
depending on ambient temperature to preheat the
engine.
5. Press fully to start the engine (position 2). Once the
engine has started, release the button, all lamps go out.
6. If the engine is fit with water cooled exhaust elbow,
check that water flows from the exhaust outlet at the
hull. If the water does not flow, stop the engine and
check the raw water system.
Without key :
1. Switch the key of the main panel to ignition (if
equipped).
2. Move the control lever to the neutral position.
ASTERN
3. Press the ON/STOP button. All the warning lamps
come on and the acoustic alarm sounds (on C4 and A4
panel). After a few seconds, only the engine oil pressure
and Battery charge lamps remain lit.
44
POSITION 2
POSITION 1/2 : preheating
POSITION 1
POSITION 2 : start
POSITION 1/2
POSITION 1
NEUTRAL
AHEAD