FUTABA 7XC Instruction Manual page 13

-S.BUS servo
This is a special function that allows setting of the parameters of our S.BUS servo whose set-
tings are changed by using PC Link software.
-MC-Link
This is a dedicated function which allows setting of the contents of the Link software which
makes possible Futaba speed controller (ESC), MC960CR, MC950CR, MC850C, MC851C,
MC602C, MC402CR, etc. variable frequency and other data changes by PC at the T7XC.
-Throttle speed
Sudden stick operation on a slippery road surface will only cause the tires to spin and the model
to not accelerate smoothly. By setting the throttle speed function, operation can be performed
smoothly and easily. It also suppresses battery consumption.
-Steering speed
When you sense that the steering servo is too fast, etc., the servo operating speed (direction that
suppresses the maximum speed) can be adjusted.
-Non-telemetry LED
When the telemetry function is OFF to con昀椀rm that the telemetry function is not operating.
-Dial select function
This function assigns functions to dials (digital trim, grip dial, knob). The step amount and op-
erating direction can also be adjusted. Trim positioning at each model selection is unnecessary
because all the dials are digital.
-Switch select function
This function assigns functions to 5 switches. The operating direction can also be set.
-Trim/dial lock functions
Lock functions which prohibit setting and operation by transmitter trim, and dials are provided.
-Vibrator built into the T7XC
The vibrator can be operated at racing timer lap navigation, time-up, and low battery, telemetry
alarm. It sets it on each function screen.
13