RCA VR552 User Manual page 7

First Things First
STEP 5: Tune THE TV
Tune the TV to the VCR viewing channel. The VCR viewing
channel is channel 3 or 4 or the TV's video input.
• If you connect your VCR using the ANTENNA connectors
with RF coaxial cable, set the 3 CH. 4 switch to channel 3
or channel 4 — the channel you want to use on your TV.
• If you connect your VCR using the AUDIO/VIDEO jacks
with audio/video cables, select the TV's video input with
the remote control's INPUT button to see the signal.
See page 52 for more information about audio input.
STEP 6: turn on the VCR
Press POWER on the VCR's front panel or the VCR button on
the remote control to turn on the VCR. The first time you turn
the VCR on, a menu screen appears. This is the start of an
interactive set up which helps you pick different options for
your VCR.
Step 7: Initial Setup
The first on-screen menu during the initial set up asks which
language you prefer to use for your VCR. Use the remote
control's number buttons to select options.
Select a language.
Seleccione un idioma.
Choisissez une langue.
1 English
2 Espanol
3 Francais
1. Press 1 for English, 2 for Español (Spanish), or 3 for Français
(French).
The remaining menus throughout the set up will appear in the
chosen language. Just follow the step-by-step procedures until
setup is complete.
If the menu does not appear:
• Make sure the TV is tuned to the same channel as the 3 CH 4
switch or the TV's video line input (see page 52 for more
information).
VCR Viewing Channel
VIDEO AUDIO
IN
OUT
A/V input/output jacks
When using the ANT IN and RF OUT
jacks to connect your VCR, tune your
TV to channel 3 or 4.
The 3-4 switch on the back of the
VCR determines which TV channel
is used to see VCR output.
When using the AUDIO/VIDEO jacks
to connect your VCR, tune your TV to
the TV's video input channel with the
INPUT button on your remote
control. For more information about
selecting your video input channel,
see page 52.
ANT. IN
RF OUT
3 CH. 4
Channel 3/4 switch
5