Table of Contents
Advertisement
Wall Mount the AP using Universal Mounting Bracket
To mount the AP on the wall, first identify the location of the wall
1. Use the mounting bracket as a template to mark the locations of the mounting holes on the bracket
2. Use a 0.1360-in. [3.4772 mm] bit to drill a pilot hole at the mounting hole locations you marked.
3. Locate the pilot holes and then insert a fastener(not included) into each mounting hole and tighten.
4. Place the universal mounting bracket over the faster holes and then use screws up to 6 mm in diameter and at least 1
- 1/4 inch length (not included) to tighten it flush to the wall
17
Advertisement
Table of Contents
