16
Wiring Installation
We recommend outdoor-suitable connectors (silicone-filled wire connectors, dielectric grease, etc.) on the
power-in connections to the control module to prevent corrosion.
Remove the (2) ¼" screws that
secure the media tray ends to
the media tray sides ( set aside
for reinstallation). Remove the
media tray end with the pilot
cover attached.
Reach into the electrical box below the pilot assembly and retrieve
the free ends of the yellow and yellow/white striped wires from the
control module.
Route the wires from the 24VAC transformer through the
strain relief at the bottom of the electrical box (below the
pilot). Use listed low voltage wiring. Make sure to
provide slack in the electrical line for removal and service.
© Travis Industries, Inc.
Installation
(qualified installers only)
8/17/22 - 1579
Outdoor Complete Linear Fire Pits