display installation
Check depth of screw threads in display before inserting screws. Inserting a screw that
is longer than the hole could result in damage to display. Depth can be confirmed by
inserting hex wrench into hole and marking its length then confirming this length is
sufficient by comparing it to the screw you are using.
1.
Attach Brackets to Display
A. Mount the display brackets to the Cisco Webex Board Pro 55" or 75" using the "T" (4) M10 x 16mm bolts
B. Attach the fixed height beam to the display brackets using the supplied "H" (4) 5/16-18 x 1/2 screws
This will act as an alignment screw for the next step.
C. Attach the shoulder washers using the "I" (6) 5/16-18 x 3/4" screws. Then refer to Fixed Height XL Stand
instructions for the remaining steps of mounting the beam to the stand
H x 4
I x 6
T x 4
Salamander XL Fixed Height Mobile Stand Designed for Cisco Webex Board Pro 75"
A
C
B
501-654 [6.22]
A
page 6 of 21