18 SERVICE WORK ON THE ENGINE
136
–
Remove screws
H01709-10
–
Pull oil filter
Lock ring plier (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surface.
H01710-10
–
Lay the motorcycle on its side and fill the oil filter housing to
about ⅓ full with engine oil.
–
Insert the new oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it together with
oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
H01711-10
–
Stand the motorcycle upright.
–
Remove filler plug
O-ring, and fill up with engine oil.
Engine oil
Info
Too little engine oil or poor-quality engine oil will result
in premature wear of the engine.
H01713-10
–
Mount and tighten the filler plug together with the O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use an effective exhaust extraction system when
starting or running the engine in an enclosed
space.
–
Start the engine and check that it is oil-tight.
5
. Remove the oil filter cover with the O-ring.
6
out of the oil filter housing.
7
.
M6
8
from the clutch cover together with the
1.2 l (1.3 qt.)
10 Nm (7.4 lbf ft)
Engine oil
(SAE 10W/50)
(
p. 155)