Changing The Combination Instrument - KTM 450 EXC-F 2019 Owner's Manual

15.12

Changing the combination instrument

Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
–
Lightly squeeze orange cap
and take it off.
–
Press the turn signal bulb carefully into the socket, turn it
counterclockwise by about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it
free from grease.
–
Press the new turn signal bulb carefully into the socket and
turn it clockwise until it stops.
Turn signal (R10W / socket BA15s) (
–
Mount the orange cap.
–
Position the diffuser.
–
Insert the screw and first turn it counterclockwise until it
E00360-10
engages in the thread. Tighten the screw slightly.
Finishing work
–
Check that the turn signal system is functioning properly.
Preparatory work
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Pull the combination instrument upward out of the holder.
V00370-10
–
Using a coin, turn protection cap
wise and remove it.
–
Remove combination instrument
–
Insert the combination instrument with the label facing
upward.
Combination instrument battery (CR 2430) (
–
Check the O-ring of the protection cap for correct seating.
V00371-10
ELECTRICAL SYSTEM 15
1
.
2
in the area of the holding lugs
p. 151)
1
with the washers.
2
all the way counterclock-
3
.
p. 118)
p. 151)
121