Toyota HILUX Owner's Manual Supplement page 22

20
1-7. Roller cover and resin sports bar
Emergency opening procedures
The roller cover can be manually
overridden by:
1. Disengaging the motor clutch
as shown.
2. Pulling the roller cover open by
hand.
Calibration procedure
In the event the roller cover fails to open and close fully, preform the
following steps to re-calibrate the roller cover:
1. Ensure the roller cover is clear of obstacles, can open and close fully
and manual override is not engaged.
2. Press the OPEN and CLOSE buttons together for 10 sec.
3. Wait for the automatic calibration process to complete.
While the calibration process is in progress, the LED illumination lamps
will flash and the roller cover will perform the following:
Close Fully > Open Fully > Close Fully > Open Fully > Close slightly to its
default open aperture.
4. Calibration is complete when the LED illumination lamps stop flashing.
Diagnostic code table
„
Interior Light
Flashing
Not
operating
–
–
Roller Cover
Slowed
Opening / Closing
Normal Opening /
Closing
Not fully
Opening / Closing
Not opening
Status
Low battery voltage
Check interior light mode
Re-run calibration procedure
Ensure vehicle is unlocked