Dolmar AX-1821H Instruction Manual page 7

Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Take particular care and attention.
･
Read instruction manual.
･
Danger; be aware of thrown objects.
･
Keep bystanders away.
･
Cutting means continues to run after
the motor is switched off.
･
Do not expose to moisture.
･
Cd Only for EU countries
Ni-MH
Do not dispose of electric equipment or
Li-ion
battery pack together with household
waste material!
In observance of the European Directives,
on Waste
Equipment
Accumulators and Waste Batteries and
Accumulators and their implementation in
accordance with national laws, electric
equipment and batteries and battery
pack(s) that have reached the end of their
life must be collected separately and
returned
compatible recycling facility.
Intended use
The tool is intended for cutting lawn edges or sprouts.
Noise
The typical A-weighted
according to IEC60335:
Sound pressure level (L
Uncertainty (K) : 2.5 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total
determined according to IEC60335:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Electric and
and Batteries
to an environmentally
noise level determined
) : 78 dB (A)
pA
value (tri-axial vector
2
) : 2.5 m/s or less
h
2
END010-4
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
Hedge trimming operation with optional hedge
shear blades
Noise
The typical
according to EN60745:
Sound pressure level (L
Uncertainty (K) : 2.5 dB (A)
The noise level under working may exceed 80 dB (A).
Electronic
and
Vibration
The vibration
determined according to EN60745:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENE015-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG905-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
ENG900-1
operator that are based on an estimation of
exposure in the actual conditions of use (taking
sum)
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG901-1
7
A-weighted noise level
) : 74 dB (A)
pA
Wear ear protection
total value (tri-axial
2
) : 2.5 m/s
h
2
ENG905-1
determined
ENG900-1
vector sum)
or less
ENG901-1