Volvo XC90 Owner's Manual page 549

WARNING
Please keep the following points in mind
when using the tire sealing system:
The sealing compound bottle (no. 8 in
•
the illustration) contains 1) rubber latex,
natural and 2) ethanediol. These sub-
stances are harmful if swallowed.
The contents of this bottle may cause
•
allergic skin reactions or otherwise be
potentially harmful to the respiratory
tract, the skin, the central nervous sys-
tem, and the eyes.
Precautions:
Keep out of reach of children.
•
Do not ingest the contents.
•
Avoid prolonged or repeated contact
•
with the skin. Remove any clothing
that has come into contact with seal-
ant.
Wash thoroughly after handling.
•
First aid:
Skin: Wash affected areas of the skin
•
with soap and water. Get medical
attention if symptoms occur.
Eyes: Flush with plenty of water for
•
least 15 minutes, occasionally lifting
17 An authorized Volvo workshop is recommended.
the upper and lower eyelids. Get medi-
cal attention if symptoms occur.
Inhalation: Move the exposed person
•
to fresh air. If irritation persists, get
medical attention.
Ingestion: Do NOT induce vomiting
•
unless directed to do so by medical
personnel. Get medical attention.
Disposal: Dispose of this material and
•
its container at a hazardous or special
waste collection point.
WARNING
Do not remove the bottle while the tire
•
sealing system is being used.
Do not remove the hose while the tire
•
sealing system is being used.
1. Turn on the vehicle's hazard warning
flashers if the tire sealing system is to be
used in an area with traffic.
If the puncture was caused by a nail or
similar object, do not remove it. It will help
seal the hole.
WHEELS AND TIRES
2. Peel off the speed limit sticker from the
side of the compressor. Affix the decal to a
clearly visible location on the windshield
to remind the driver not to exceed this
speed limit. Do not drive faster than
80 km/h (50 mph) while using a tire that
has been temporarily repaired with the tire
sealing system.
3. Make sure the switch is in the 0 (Off)
position and take out the electric cable
and the hose.
4. Unscrew the orange cover on the com-
pressor and unscrew the cap on the seal-
ing compound bottle.
5. Screw the bottle onto the bottle holder as
far as possible.
The bottle and the bottle holder are equip-
ped with catches to help prevent the seal-
ing compound from leaking. Once the bot-
tle is screwed into place into the bottle
holder, it cannot be unscrewed. The bottle
can only be removed by a workshop
WARNING
Do not unscrew the bottle. It is equipped
with a catch to prevent leakage.
17
.
}}
547